Leeches and Ticks

On a recent trip to VK4 I wanted to get in a couple of summits, so a quick look before going, and tried to work in a couple with where I would be and I ended up getting up to 2 Summits – VK4/SE-117 and then VK4/SW-001  As an added bonus, VK4/SW-001 is also in the middle of the Bunya Mountans National park – and VKFF-0067

Friday 23rd October – Tenision Woods Mountain

First off VK4SE-117 – Tenision Woods Mountain   a 6-pointer, looked to be easy from the Maps – with the summit a few hundred metres off the Mt Glorious road, about 2km West of Mt Glorious –  which itself is to the North-West of Brisbane.

As it turned out, it was an easy to access summit – with just enough room on the Mt Glorious Rd for 1 car to pull over on the track to the summit.  An un-expected surprise, was that the path to the summit was fenced with a National Parks’ sign on the gate!  So, I suspected, that this was also a VKFF location as well.

Now I am home, I have searched out the details and sure enough, Tenision Woods Mountain is within the D’Aguilar National Park, and is VKFF-0129.

Ok, onto the Activation. First off the Locality photos- 20151023_135450

The Sign at the side of the road at the track up to the summit.

20151023_140333
The plaque located right at the summit.

20151023_142111

The “shack”  Sitting on a log on the side of the walking trail just back from the comms tower at the summit.

As I was flyig to VK4 I was not able to pack my squid pole and had to rely on just throwing a rope over a convenient tree branch to pull up the Dipole.  I managed to get it about 5m high in the center in the rainforest.

Now, the first part of the blog post will become obvious – The Leeches -Yep, there rainforest here was home to leeches and the little blood-suckers jumped on everyone but me! So, take my advice – carry the insect repellent and apply liberally before venturing onto this summit!

Now, this was probably a bad time to be actually activating the summit it was Friday 23rd Oct in the mid afternoon – just after 04:00 UTC when we made it to the summit on the drive thru and were set up.   Knowing that I only had a short time, I only planned to activate on 15M and then 40M (both just using the 40M dipole).

I was able to post an alert and then post a spot as I set up and it wasn’t long before I was rewarded with my first contact.  Logging just 2 contacts on 15M and then jumped down to 40M where we were rewarded with a further 9 contacts (with 7 uniques).  As I had just 9 unique calls in the logs I decided to give 20M a quick go – to try and get the 10 required for VKFF – and   making it a valid VKFF activation as well, so I decided to give 20M a quick try.  I was rewarded with my efforts with a further 4 contacts – and 2 more uniques to give me 11 unique contacts for the dual activation.

With contacts to VK4, VK2, VK3 and a single DX contact to RA3PCI it was successful for my first VK4 Activation.

We packed up, did a double-check for leeches and headed off to our destination.

Saturday/Sunday  24/25th October – Mt Kiangarow / Bunya Mountains

I had planned to spend a couple of hours on the Sunday Morning and activate the 10-pointer VK4/SW-001 across the UTC roll-over on the Sunday Morning.  I had already determined that this would be a dual activation being within the Bunya Mountains National Park VKFF-0067.

With the Guys meeting in Wagga Wagga and the expected activity of several summits being activated in the Riverina Area of NSW, I was hopeful of at least a couple of S2S contacts.

Like Tenision Woods Mountain this summit was one that was
reasonably accessable with a rad thru the National Park, and a short  1.3km walk along a well-maintained track to the Summit lookout.

20151025_091119

The Sign showing the walking trail around and up to the summit.

20151025_091011

The entrance to the track to the summit.

After an easy 15 minute walk up the track you could se thru the rainforest a comms tower on the summit, and about a 100m further on we came to the end of the track, with spectacular views out to the north and a convenient seat!

20151025_105434

Sitting on the seat on the Summit.

As it was only 15 minutes util roll-over, I wasted no time in getting the Dipole strung up.  Unlike on Friday, there were not many tall tree’s here and I really wished I had a squid pole, but made do with what I had – and the dipole was strung up about 3m from the ground!

I decided to work 40M before roll-over to maximize the chance of a as many contacts as possible -and managed to get 5, including 2 operators on VK2/RI-031.

Post roll-over, I stayed on 40M and continued to work contacts and again worked the 2 Activators on VK2/RI-025 for some more S2S action.

I worked 10 contacts on 40M before moving onto 15M and worked a further 4 chasers before jumping onto 20M, working another 8 chasers including a S2S contact to VK2/RI-026.

On a whim, I jumped onto 10M and worked my only DX for the day and also my only contester (CQWW) W5PR in Texas. and again a repeat chaser as well.

I took a look over my logs and decided o jump back to 40M after looking at the spots in an attempt to work a couple more S2S contacts.  I tried and tried but had an incomplete – the other station could not hear me and was about to give up and finally completed a contact with my 4th S2S for the day to VK1/AC-009.

I was well please with this contact as It gave me something new that I had never done before when activating any summit – that last contact put into my Log  VK1, VK2, VK3, VK4, VK5, VK6, VK7 and VK8 from the same summit (across 4 bands) -and all using just 10W with the KX3 and a dipole that was no more than 3M high!

20151025_105428

Another shot of the shack for the day – with the stunning views!  That black thing in the top right is the winder at the end of my dipole about 2M high!

Yes, I do have more photos but have not pulled them off the camera yet – I’ll get to them soon!

It was nearly 2 hours, and  S2S with 4 unique summits, working All VK call areas except VK0 and VK9, some (well a single) DX and a total of 26 contacts (22 uniques) it was a great day to be out Portable.

Again, I had enough chasers to make this a successful VKFF activation.  I’ll get the logs up in the near future!

A big thanks to all the chasers who made the 2 activations I did in VK4 a success.  Yes, conditions were a bit tough and I know that there were a few that I just could’t hear, but next time!

I almost forgot – the Ticks – Well, yep, when we got home, I discovered that I was the unlucky one this time and picked up a couple of ticks!  1 uner the arm and another one on the other arm – so yeah, should have sprayed on the Aerogard!

2 new summits,  1 New association and I can’t remember who, but I even managed to give out a complete on VK4/SW-001 to someone else who had activated it on a recent trip to VK4.

I just wished that I had more time and had a chance to see more of the summits in VK4 – but there is always next time and a lot of summits to chose from!

It has been a while

… since the last time I have managed to get out portable, but this afternoon,  the opportunity came up and I grabbed it with both hands.

Yes, the band conditions were not great wtih a CME less than 48 hours ago, but regardless, I still went out.

The location was Mt Gawler – VK5/SE-013 and today, I chose just to operate 15M then 40M, both off the 40M inverted V.

Firstly, it was good to see that the vegetation is slowly regenerating after the fires.

20151009_191136

Well, a few things have changed with my setup since last time that I was literally trialing in the field for the first time.  Firstly, the new KX3 firmware that will allow 10W output with a power supply voltage above 10V.  This change means that I can use a 3S lipo and eliminate the (noisy) DC-DC converter I was using with the 4S lipo.  Glad to say it worked out great – and everything worked as expected.

The 2nd one is the ever-elusive quest to simplify logging!

20151009_184748

Yep, got a QRPWorks SideKar to go with the KX3 – and a micro wireless keyboard to drive it.

20151009_184840

A bit more on it shortly…

It was a really pleasant afternoon and started on 15M

Posted a spot and started calling and only had a single contact on the band – VK5PAS.

After abut 20 minutes of calling CQ SOTA (thank heavens for the voice keyer and playback repeat functions of the KX3!) I moved to 40M and again started calling.

Like 15M the bands were pretty quiet but with the alert, over the next  hour, I put a further 10 contacts in the log.

As expected because of the conditions and time of day there was not much close-in activity – just a couple of mobile stations.

A few of the regular chasers were there, but a surprising number of VK6 stations came back to me – I have never had 3 VK6’s in the log on 40M from here before!

Stations Worked on 40M

VK3PF, VK2IO,VK6NU, VK5AK/M, VK1MA, VK2HRX, VK6NK, VK2JAZ, VK6WE/P and VK5FSPJ

Now, Simon, VK2JAZ was asking what I could see from up at Mt Gawler – so I told him exactly what I was seeing – the sunset – and as promised – here is the photo of the sunset I took while we were talking – the photo does not do it justice!20151009_191840

Now, onto the SideKar.

Well, it was a little bit of getting used to using it – and today, I was thankful of it being fairly slow so I had plenty of time to actually use it and get to know how to do the logging.

At the start of the session, I had to read the manual – on how to do some of the setup.  This device is specifically designed with SOTA in mind – and first things I did was to set the clock,  then set my SOTA Reference.  From there, it was pretty much just learning the keyboard shortcuts to make a log entry.

As the SideKar interfaces to the KX3, I did not have to be concerned with frequency and time – it was all recorded with each log entry.

I  was able to enter every contact into the SideKar in real time, It is a couple of keystrokes and all good!

Now of course, with the logs being entered real-time and then when I got home it was simply a matter of exporting the ADIF right from the SideKar to the computer.

As we all know – we need a V2 CSV format for uploading the logs – and I managed to find an online converter to do this.  The converter was not perfect, but took care of most everything – with just a few minor edits needed to get it ready to upload.

I guess that I’ll look at developing a suitable conversion App in the future to export the ADIF as needed for upload to Sotadata.

Now, one of the issues I have had is managing the logs for WWFF – and now, I will be a lot closer to making this a lot easier as well in the future.

Of course, you will see that I used a very small wireless keyboard for interfacing with the SideKar – and it is perfect in so much as it is very lightweight – less than 50g.  You can use any USB or 2.4G Wireless keyboard, so a bigger keyboard might be used in the future for contesting etc, but for now – the lightweight one wins out.

At the moment, I have not really used the other features of the SideKar – extended display for PSK, RTTY and CW, but there is plenty of time for that.

As toys go – Pretty happy with this one, knowing that it makes the job of logging for the portable awards much easier.  Not only is it small and lighter than a laptop – it is useable in full sun – unlike the laptop!

Yes, a big success – and it is going to simplify my logging.

Ok, yeah, I know it turned into a mini-review of the SideKar, but by lowering the burden of having to enter all the paper logs when you get home, it makes the whole idea of going portable a lot more attractive!